Morningstar MPPT 600V Solar Charge Controller With Transfer Switch and GFPD
NOTE: This model comes with the pre-wired ground fault protection device (GFPD-600V).
The Morningstar TS-MPPT-600V-48-DB-TR-GFPD is designed to handle much higher string voltages than traditional charge controllers. Because it can handle up to 600 volts open circuit (Voc) solar input, that means you can cut down on your installation time and costs. By using a high voltage string, you can use smaller wire to complete the installation and use a smaller combiner box. The unit is designed and factory preset to work only with 48 volt battery banks. It has one of the best conversion efficiency ratings in the industry and optimizes battery health with its advanced four stage charging algorithm. It also has built in electronic protection against lightning and transient surges. For off-grid PV systems with 150VDC or greater open circuit voltage (Voc) and long wire runs, this charge controller is perfect.
If you have a grid-tie solar system and want to add battery backup, this controller with a built-in transfer switch makes that an easy task. In the case of a grid power outage, you simply set the transfer switch to battery power, which uses your existing solar array to charge your battery bank. The battery bank powers an inverter that supplies power to an electrical panel for critical loads. Watch the YouTube video below to learn more about using the transfer switch with battery backup.
Peak Efficiency 97.9% Maximum Battery Current 60 Amps Maximum Open Circuit Voltage (Voc) 600 Volts DC Input Operating Voltage Range 100 - 525 Volts DC Nominal Solar Input 3,200 Watts Nominal System Battery Voltage 48 Volts DC Self Power Consumption 1.75 - 2.5 Watts Transient Surge Protection 4,500 Watts/port Wire Size Range #14 AWG - #2 AWG Enclosure Rating Indoor Use Only Dimensions 21.4" x 8.7" x 5.9" Weight 28.1 pounds Warranty 5 Years
- Additional Information
SKU TS-MPPT-60-600V-48-DB-TR-GFPD Bundle Pre-Configured Price No