Schneider Electric C60 60 Amp Solar Charge Controller
C60 Charge Controller- 60 Amp. 12/24 VDC
A Controller for Virtually any DC Charging Source.
All Schneider Electric controllers are UL and cUL listed. C Series controllers may be configured for PV battery charging, or DC load control or DC diversion operation.
Silent Microprocessor Control
All C Series controllers have a microprocessor at their core which increases system performance and maximizes battery life. They are fully solid state and operate silently.
PWM Charge Performance
All Schneider Electric controllers all use Pulse Width Modulation (PWM) charging profiles which are designed to provide a full charge to your battery while, at the same time, minimize gassing which can shorten battery life.
3-Stage Battery Charging
All controllers automatically initiate a 3-stage battery charging cycle. Bulk, Absorption, and Float modes are used to ensure that voltage and current settings accurately match the batteries actual state of charge. This means fast-as-possible charging and extended battery life. An auto equalize mode can be easily switched off when the controller is used with sealed batteries. C Series controllers are factory set for solar PV battery charging operation.
There are a number of field configurable, user adjustments for C Series controllers. C35 and C60 can only be set for 12 or 24 VDC operation. The C40 may be configured for 12, 24 or 48 volt systems. Bulk and Float voltage set points are user adjustable which allows use with a wide variety of battery technologies including; flooded lead acid, gel, and absorbed glass mat. In addition, there are manually selectable settings for Nicad batteries. [Note - we do NOT recommend changing the factory settings except under unusual conditions.]
DC Diversion Mode
In this mode, all power, which is not used to maintain a full charge on the batteries, is diverted to a load dump such as water or space heaters. Diversion mode is used to regulate microhydro and wind turbine systems which need a constant load.
LED Status Indicator
A simple to read, multi-color LED indicates operating status and is standard on all C Series controllers.
UL and cUL Listed
C Series controllers are listed by UL to exacting UL 1741 and cUL CSA 22.2 107.1-95 standards. C Series controllers are also CE compliant (European countries) and are designed to CTIK standards (Australia). Their current ratings are real world and do not have to be derated to comply with USA NEC 125% overcurrent requirements.
LCD Digital Display
CMR/25, CMR/50 or CMR/100 A back-lit meter which continuously displays: battery voltage, DC amperage, cumulative amp hours and amp hours since last reset. The remote meters CMR/25, CMR/50 and CMR/100 use simple plug-in connectors. 25 ft. (7.5 m), 50 ft. (15 m) or 100 ft. (30 m) cable included.
BTS/15 or BTS/35 Monitors battery temperature and adjusts charging voltage for maximum performance. A 15 ft. (4.5 m) or 35 ft. (11 m) cable with standard telephone type connectors is included.
NOTE: If you have a larger solar system that can put out more than 30 amps, or have a 48 volt system, we recommend the Outback Power FM60/80 MPPT, MidNite Solar Classic, or the Conext XW-MPPT-60 charge controller. They are more expensive, but they will give you about 15% to 25% more power out of your panels.
2 year warranty